Single-Shaft Shredders Series P

Single-Shaft Shredders Series P are low-speed shredders used for shredding of a diverse small wood residue. The processed material dimension is limited by the thrust’s width and height in order to prevent jamming of material in the hopper. The material is pressed towards the rotor by the hydraulic thrust. The blades separate the material against a counter-blade; the material is being pulled down under the rotor, passing through a separating screen that is mounted in the machine column under the rotor. Finished chips are discharged into the area below the separating screen. The further chip transport takes place according to the specific conditions and requirements of the customer.

The machine can operate without need of operators presence. The machine operates on lower noise level and can be installed inside the plants. Dustiness depends on the type and humidity of the processed material. The shredder must be installed at least under the roof in order to be prevented from direct influences of weather.

1 STERE = 0,50 – 0,75 CUBIC METR (m3)

for the following type of mateials such as slabs, cut-offs, etc.

FAQ

1

Can I attend a test pressing?

Trial pressing is carried out free of charge and without any obligation on your part in our Technical Center using your own material. If you wish, you can attend the test press.

2

Do we need to crush/shred the chips before briquetting?

In the case of long, woolly chips, it may be necessary to crush the starting material beforehand. In this case, we can offer complete solutions together with the relevant suppliers. With our free pressing test, we can establish whether your starting material can be briquetted or whether it needs to be crushed beforehand.

3

Is there a universal shredder for logs, slabs, etc.?

No, there is no universal grinder.

4

Is pallet shredding possible?

Yes, this technology exists.

5

Is there a complete grinding solution?

 Yes, some of our suppliers offer a complete solution, the cost depends on the technical task or on the required performance

6

Which chipper model is suitable for my chips?

The model of the grinder is selected depending on the material, volume, mode of operation.

Ask a question

Didn't find the information you are looking for? Ask your question and we will answer it as soon as possible.

By clicking the "Send" button, I give my consent to the processing of personal data and accept the terms of the privacy policy.

We recommend seeing

Drum chipper

Details

Horizontal shredders

Details
Jersikas street 14,
Riga, Latvia, LV-1003
on working days: 08:00 - 17:00 +(371) 67 286 442
for questions and offersrmp@rmp.lv

Thank you!

Your message has been sent.

Have a question?

We will answer! Order a call from our manager.
We usually call you back within 15 minutes.

By clicking the "Send" button, I give my consent to the processing of personal data and accept the terms of the privacy policy.

Order a leasing calculation

By clicking the "Send" button, I give my consent to the processing of personal data and accept the terms of the privacy policy.

To send a resume

Contact details
vacancy
comments
By clicking the "Send" button, I give my consent to the processing of personal data and accept the terms of the privacy policy.
Didn't find the information you are looking for?

Contact us

Contact details
comments
By clicking the "Send" button, I give my consent to the processing of personal data and accept the terms of the privacy policy.